1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 187Get this manual
r,Ql 14Slide the propeller shaft onto the shifter shaft, align the
hole in the shaft with the hole in the clutch dog, install the pin and then, new clutch dog retaining springPosition three coils over each end of the pin, making sure none of the coils overlap or are loosebearing housing with the detent lever toward the topPush the detent lever down, into REVERSE positionBe sure the thrust bearing and the thrust washer are properly positionedInsert the propeller shaft assembly into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housingf12l 16Lubricate two new shift rod cover a-rings with OMC Triple-Guard greaseInstall the a-rings into the shift rod cover1,3l 17Place the shift rod grommet and shift rod spacer (EX models) on the shift rodGrease the threaded end of the shift rod and insert it through the coverTurn the shift rod while pushing it through the cover to avoid damaging the -rings