1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 182Get this manual
1,;1 6Use OMC Seal Installer, PIN 336311, to install two new seals back to back in the rear of the bearing housingApply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing r:;J 7Lightly apply OMC Triple-Guard grease to new bearing l.ZJ housing a-ringInstall the a-ring in its groove in the housingDriveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged
Remove the two driveshaft bearing housing seals using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the seals