1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 181Get this manual
Propeller Shaft Bearing Housing Service
l!J and OMC Large Puller Jaws, PIN
[";1 1Remove both seals using OMC Puller Bridge, PIN 432127, 432129Position the plate on top the housing to support the bridge, and tighten the jaws securely behind the lower sealInspect bearings in placeIf bearing is removed for any reason, it must be discarded
[:;l 2Remove either bearing using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Rest the puller plate on top the housing to support the bridge, and tighten the jaws securely behind the bearing
3Discard the bearing housing O-ringClean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect O-ring groove, and sand off any sharp edges that would cut O-ring and prevent its sealingrJl 4Inspect the bearing housing anodeReplace anode if it has reduced to two-thirds of its original size (one-third eroded)f411sl 5Oil, then install new bearings in the bearing housing Use t=.I OMC Bearing Installer, PIN 339750, to install the forward bearing and rear bearing Place the lettered end of the bearing case on the bearing installer, then press the bearing into the housing until the tool seats27024