1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 180Get this manual
f18l 19Pull up on the detent lever until it snaps into NEUTRAL positionPush the pivot pin out of the housing, then reach inside and pull the shifter off the detent lever
i ball and spring can come out with great force while removing the detent
'" Wear safety glasses to prevent personal injuryThe detent
'19l 20Wrap the housing with shop clothRotate the detent lever 90 in either direction, then pull the detent lever out of the housing 1201 21Remove the detent ball CD and spring Q)Remove the 25 forward gear needle bearings22The forward gear bearing and bearing housing are serviced as an assemblyIf either are worn or damaged, replace the entire assembly23Remove the pinion bearing only if it needs to be replacedBefore attempting removal, take out the bearing retaining ring CD on top side of the pinion bearingIf the pinion bearing must be replaceduse OMC Bearing Remover and Installer, PIN 391257, and assemble it as follows: