1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 177Get this manual
Disassembly 1Remove the propeller and mounting hardwareInspect the propeller for spun hubf11 2Remove the oil level plugthen the drainlfill plugand drain the lube from the gearcase into containerInspect the lube and the magnets on the plugs for metal chipsThe presence of small metal chips can indicate normal wear of the gears, bearings, or shafts within the gearcaseLarge metal chips can indicate extensive internal damageMake note for future reference while inspecting internal componentsInspect the drained lubricant for water or burned odorWater in the lubricant will give it milky appearanceOverheating will give the lubricant black color and burned odorf21 3Remove the two screws, washers, and retainers holding the propeller shaft bearing housingf31 4Remove the propeller shaft bearing housing from the gearcase using the following: Puller body, pressing screw, and handle from OMC Universal Puller Kit, PIN 378103 Two 5 16-18 11 in(279 mm) threaded rods, two large 5 16 in LDflat washers, and two 16-18 nuts (obtain locally)Assemble components and pull the bearing housing from the gearcase