1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 162Get this manual
6Install the trail lock lever, detent, handle, and bushing in the starboard stern bracket22 7Route the trim sender wires through the braided tube and install the sender unit in the port stern bracket12324 8Install the upper and lower steering shaft bushings and new seals in the swivel bracketBoth seal lips face out Coat the seals' outside surface with OMC Gasket Sealing Compound Coat the bushings and seal lips with OMC Triple-Guard grease25 9Coat tilt tube bushings with OMC Triple-Guard grease and, if removed, install them in the swivel bracket2627 10Place the swivel bracket between the stern brackets and install the anodeInstall the tilt tube using the adapter from OMC Steering Tube Service Kit, PIN 434523, and soft face malletStart the tilt tube from the port sideDrive the tube through the starboard half of the bracketBe sure the lock tab on the port side of the tilt tube is in proper position 30761