1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 139Get this manual
r,v 14Inspect center main bearing and split sleeves for excess
wear, nicks or scratchesReplace if necessaryf12115Inspect crankshaft rod bearings for excess wear, nicks or scratchesReplace if necessaryAssembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson and Evinrude Outboard Lubricant
rv Sleevethe end of the crankshaft.and place new lower main 1Oil Use OMC CrankshaftBearing Installer, PIN 338647,
bearing onto crankshaft with lettered side facing the toolInstall bearing until it seats in the crankshaft
Use new wrist pin retaining rings, gaskets, seals, and a-rings during assembly
t=I Crankshaft BearinglSleeve Installer, PIN 338647, and drive the
f212Oil the end of the crankshaftPlace new sleeve in OMC sleeve onto the crankshaft until the installer contacts the lower main bearing If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PIN 391008, into installer and pu II offInspect sleeve surface after installingSleeve must not be used if surface is damaged