1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 128Get this manual
Thermomelt Stik Procedure
i lers to avoid accidental starting of engine
'" Twist and remove spark plug leads before changing propel-
1Install correct test propeller and place engine in test tank2Start engine and run at 3000 RPM for at least five minutesf31 3Reduce engine speed and run engine at 900 RPM for five minutesMark both cylinder heads with 1250 (52 C) and 1630 (73 C) Thermomelt Stik4At 900 RPM, the 1250 (52 C) marks should be liquid and glossyThe 1630 (730 C) marks should remain dull and chalky If the 1250 (52 C) marks are not liquid and glossy, troubleshoot the cooling system for causes of over cooling If the 1630 (730 C) marks become liquid and glossy, troubleshoot the cooling system for causes of overheating f31 5When the engine speed is increased to 5000 RPM, both 1630 (73 C) marks should remain dull and chalky If the marks become liquid and glossy, troubleshoot the cooling system for causes of overheating