1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 118Get this manual
STEPCHARGE COIL TEST Ground Test
1Disconnect 6-pin Packard connector between stator and power pack2Attach 6-pin Packard test adapter from OMC Ignition Test Kit, PIN 434017, to stator connector3Set peak-reading voltmeter to
Connect the meter black lead to clean engine groundAlternately connect meter red lead between brown, brownyellow stator leadsCrank engine and observe meter at each connection: Any reading indicates charge coil is grounded Locate and repair ground, or replace stator assembly
5Repeat Step using brownblack and brownwhite stator leads6If no reading is indicated in Steps or 5, go to Output TestOutput Test
1Set peak-reading voltmeter to "POS" and" 500"
f2l 2Attach meter black lead to brown stator leadAttach meter red lead to the brownyellow stator