1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 115Get this manual
2 DINZIOA
DIN281A
Ohmmeter TestShift Switch
INotel All ohmmeter tests must be performed with the engine NOT running'2l1Calibrate ohmmeter on appropriate scaleConnect between shift switch end of harness and clean engine ground Meter must show high reading If meter shows low reading, replace switch and harness2Activate switch by pushing down on shift cable pin Meter must show low reading If meter shows high reading, replace switch and harness3Connect ohmmeter between both switch harness 1-pin connectors and note the reading4Reverse the meter connections or press "polarity" button, and note the reading high reading in one direction and low reading in the other direction indicates the harness blocking diode is good If your test results vary, replace the switch and harness5Complete all circuits disconnected during this test