1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 95Get this manual
1141 5Wrap single layer of cellophane tape around the crankshaftBottom of tape should be just below the crankcase flatsThe tape will protect the flywheel cover seal from damage during flywheel cover installationf151 6Be sure the wave washer is positioned on the starter pinion shaft f.i61 7Carefully install the flywheel coverRemove the tape from
the crankshaft after the cover is seated
8Install the 17 flywheel cover screws and tighten to 40-50 inIbs(4,5-5,7 Nm)9Install the spark lever assembly on the throttle camshaftSecure the spark lever assembly with the retainer
10Position the timing wheel on the crankshaftInstall the timing pointer and adjust it as described in Synchronization and Linkage Adjustment, Section 1r,]l 11Remove old adhesive from the threads of the timing