1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 79Get this manual
7Install the nozzle well gasket
1321 81331 9
Clip float valve to floatInstall float assemblyTighten hinge pin retaining screw securelyInstall float bowl gasket
Adjust float height with carburetor body invertedFloat must be level with gasket surface 132 in(0,8 mm) If adjustment is required, do not put pressure on float valve and seat10Adjust the float drop with carburetor body in normal positionThe drop dimension to bottom offloat should be between 1V1S-11S inmm)
11Install high speed fuel orifice with OMC Driver, PI 317002, and install float chamber plugTorque plug to 30-35 inIbs(3-4 Nm)
their holes to engage original threadsTorque screws in sequence to 18-24 inIbs(2-3 Nm)