1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 61Get this manual
Disassembly All screws addressed in this procedure are No15 Torx i when removing screws and releasing that pressure
'" The air motor cover is under spring pressureUse caution
L!J holding the air motor coverTo control the spring
Set cover, screws, O-ring, and two springs aside
[";l With No15 Torx screwdriver, remove the Torx screws
pressure, place pump on your bench with the air motor cover facing upwardHold down on cover while removing screws
r:;] Remove the Torx screws attaching the inlet housing to the
intermediate housing and separate these partsAs you lift the inlet housing, the oil piston will be drawn out of the oil pump