1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 56Get this manual
6Test the "no oil" warning circuit: Connect shop tank with 50: fueloil mix to the fuel inlet fitting Remove the protective cap from the oil inlet fitting Start the engine and run it at 1000 RPMin gear After the residual oil is exhausted from the oil line, the "no oil" circuit should activate the warning horn The signal should be an urgent off12
second on, 112 second
"low oil" and "no oil" warning circuits alert the operator to possible problems with the VRol systemYou must be sure they are functional before continuingIf they are not functional, serious powerhead damage might occur
7Complete the installation by connecting the oil supply hose to the engine's oil inlet fitting
f21 'al Before attaching hose, squeeze oil primer bulb to purge
all air from oil lineAllow small amount of oil to flow from the hose to remove any contaminants that might be in the line