1993 Johnson Evinrude "ET" 60 degrees LV Service Manual, P/N 508286, Page 28Get this manual
AnodesTesting and Replacement Erosion or disintegration in salt or brackish water indicates the anodes are performing their functionThe anodes should be inspected at intervals and replaced when necessary, or corrosion of the engine will increase
If any anode has been reduced to 03 its original size (1f3 eroded), it must be replaced!
Test for proper installation of the anodeCalibrate an ohmmeter on high ohms scaleConnect one meter lead to powerhead ground and the other lead to the anodeBe sure the surface of the anode is clean to make good contactThe ohmmeter should show low readingIf not, remove the anode and clean the area where the anode is installedThe mounting screws and the anode itself should also be cleanedInstall and retest