1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 320Get this manual
Cable InstallationEngine ill '" To prevent accidental starting of engine, verify that battery cables are disconnected at battery
Throttle Cable
1Remove the rubber grommet from front of lower engine coverRemove cable retainerApply liberal amount of OMC TripleGuard grease to both anchor block pockets
rv greasethrottle cable and lubricate with OMC Triple -Guard 2Extend
3Verify that the fast idle lever is down in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmentFailure to follow this procedure exactly might cause accelerated wear of shift system components and high shifting effort5eng.ine lever so that the spark lever stop screw IS agamst ItS stop 6Attach the throttle cable casing guide to the throttle lever lower hole using pin and cotter clip suppliedThe cotter clip must be installed parallel to the raised rib