1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 316Get this manual
3Lubricate cable ends with OMC Triple-Guard grease f31l '"
4Begin cable installation with housing half of controlTo install throttle cable, move throttle lever arm from behind plastic plate to expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin CD and drop cable pin through upper lever arm, through eyelet, and into lower lever arm
1321 5Grease cable trunnion pocket and insert cable trunnion
into trunnion pocket in housing half6The throttle lever must be in the idle position before reassemblyMove it forwardtoward the front of the housing half until it contacts the stop
1341 7To install shift cable, grease trunnion pocket in cover halfGrease cable pin, place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin
1341 '" 8Shift lever must be in NEUTRAL before reassembly of