1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 267Get this manual
6Examine the pulley and the starter housingLook for sharp edges and rough surfaces that could fray the starter ropeFile and polish to remove7Examine the starter and starter lockout partsReplace any worn or damaged partsAssembly
"'" Wear safety glasses while disassembling and assembling manual starters because of rewind spring tension
IT!] 1Place the starter spring shield into the starter housingr:w2l2Using OMC Starter Spring Winder and Installer PIN 392093, clamp spring winder base in viseInsert release plate into spring winder base
r.J3l 3Apply OMC Triple-Guard grease or Lubriplate 777 to the
rewind springInstall the rewind spring into the spring winder base with open loop of spring facing inwardInsert the pin of the crank and pin assembly into the loop of the rewind springSecure the crank and pin assembly to the starter winder base with the crank retainer screw