1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 252Get this manual
r:J5l19Remove thrust washer and collar from driveshaftRemove retainer ring if requiredr;;] 20To assemble bearing to driveshaft, make sure bearing
retaining ring is in position on the driveshaftApply light coat of OMC Marine Wheel Bearing Grease to the bearing and driveshaft pressing surfacesPress bearing onto shift until bearing makes contact with retaining ring
r:J7l i'"l sureUsing retaining 21l the
pliers, snap ring Make ring IS seated In ItS groove In the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from the pliersthe driveshaftApply OMC Triple-Guard grease to two new O-rings and install on upper seal carrier