1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 237Get this manual
COA3580 DR2061
29307Oil, then install new bearings in the bearing housing using OMC Bearing Installer, PIN 326562 Press
against the lettered side of the bearing to prevent damage to the bearings when installingseals back to back in the rear of the bearing housingApply OMC Gasket Sealing Compound to the meta casi ngs of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installingr:;;l9Lightly apply OMC Triple-Guard grease to new bearing housing O-ringInstall the O-ring in its groove in the housingInstall new O-rings on the retaining screwsDriveshaft Bearing Housing Service If the needle bearing in the housing is worn, the bearing and housing must be replaced as an assembly
rJil328Use OMC Seal Installer PIN 326551 to install two new