1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 218Get this manual
Propeller Shaft Bearing Housing Servicing Inspect the bearings in placeIf bearing is removed for any reason, it must be replaced 1291.f311 useToOMCBearing Pullerseals, 432130and rear bearings, remove the two PI front attached to either OMC Slide Hammer PIN 432128 or OMC Puller PIN 432127 Thoroughly clean the housing in solventBridge 2Install new bearings in the bearing housing using OMCBearing Installer PIN 334997 Oil and place new forward bearing on the tool with lettered side of the bearing facing the toolInstall the bearing until the tool contacts the housing15500
1331 Oil and place new rear bearing on the tool wit lettered
side of the bearing facing the toolInstall the bearing until the tool contacts the housingr::;;l r:;;l 3Install new seals back to back in the rear of the bearing housing using OMCSeallnstalier PI 910585 or 326556Apply OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing toward the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing