1993 Johnson Evinrude "ET" 40 thru 55 Service Manual, P/N 508283, Page 127Get this manual
IGNITION OUTPUT TESTSUFI ill plugs installed and torqued in the cylinder headIf necesI.A All cranking output tests must be performed with spark
sary to remove the spark plugs, be sure to keep the spark tester away from open spark plug holesThe following series of steps will systematically isolate problem area in the ignition systemTo reduce your troubleshooting time and to avoid incomplete results, perform these steps in the order written
STEPTOTAL OUTPUT TEST
f1l 1Twist and remove the spark plug leads from both spark
12 in (12 mm)Connect tester leads to the spark plug leadsSecure tester clip to clean engine ground
r:;"] 2Adjust the gap on the spark tester to
To prevent possible arcing of high voltage, route tester leads at least in(51 mm) from any metal surface
i or spark tester during cranking tests