1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 249Get this manual
Note location of rope anchor point and carefully pre-tension spring by turning pulley counterclockwise to 4V2 turnsuntil rope anchor is opposite rope guide f.i316a pul!ey and pulley position agamst spring tension 7Connect handle to rope as shownhousing to hold
r:J5l8Using sharp, hooked pinthread rope through rope guidedown through pulley rimand up through rope channel to anchor point Knot rope and pull knot into anchor point
11619Remove tool and let spring slowly wind rope onto pulleyRei nstall pawl components as an assemblyInstall E-ring with sharp side upInstallation