1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 219Get this manual
Assembly
12211Oil and install new a-ring into new shift rod bushing
Assemble the Bushing Installer to the Rod (components of OMC Driveshaft Bearing Remover and Installer, PIN 393092)Place the bushing onto the Bushing and Installer with a-ring downApply OMC Adhesive sealant to the outside of the bushingUsing mallet, drive the bushing into the gearcase until seated
1231 To install new lower driveshaft bearing, assemble com2
ponents of OMC Driveshaft Bearing Remover and Installer, PIN 393092 (RodGuide PlatePinand Small Disc with concave side toward bearing), as shownPlace the lettered side of the bearing toward the small discUsing mallet, drive in the lower bearing until the pin comes in contact with the guide plate
1243To install new upper driveshaft bearing, assemble components of OMC Driveshaft Bearing Remover and Installer, PIN 393092 (RodGuide Plateand Large Disc with concave side toward bearing), as shownPlace the lettered side of the bearing toward the large discUsing mallet, drive the upper bearing in until it is seated firmly