1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 218Get this manual
115112Remove and discard both gearcase head sealsUse OMC Puller Bridge, PIN 432127, and OMC Small Puller, PIN 432131116113Remove and discard the gearcase head bearingUse OMC Bearing Removerllnstaller, PIN 392091 rr7l14Remove and discard both driveshaft sealsUse OMC Puller Bridge, PIN 432127, and OMC Small Puller, PIN 432131 r,sl15To remove the upper and lower driveshaft bearings, assemble the components of the OMC Driveshaft Bearing Remover and Installer, PIN 392092 (Guide PlateSmall Disc with flat side toward bearing, and Rod ), within the gearcaseAttach OMC Slide Hammer, PIN 391008, to the rod and remove
both bearings at the same time119116To remove the forward gearcase bearing, assemble OMC Puller Bridge, PIN 432127, and OMC Bearing Puller, PIN 432130Make sure that the jaws of the puller are oriented vertically and then extract the forward bearing 120117To remove the shift rod bushinguse components of OMC Driveshaft Bearing Remover and Installer, PIN 392092 (Guide Plate and Rod )Thread the top ofthe rod into the shift rod bushingAttach OMCSlide Hammer, PIN 391008, to the rod and remove the bushingDiscard both the bushing and O-ring121118Using OMC Bearing Remover and Installer, PIN 392091, oil and drive new gearcase head bearing into the gearcase head The lettered side of the bearing must go toward the tool to prevent damage to the bearing