1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 211Get this manual
I o 25537
Assembly Make no dry assembliesLubricate bearings, shafts, and gears with OMC Hi-Vis gearcase lubricantr:t5l1 To install new forward bearing, assemble OMC Collar, PIN 115313, to OMC Bearing and Seal Installer, PIN 115310Place the lettered side of the bearing to the collarSupport the nose of gearcase on block of wood on the floorUsing mallet, drive the forward bearing in until it is seated
1161 2To install new lower driveshaft bearing, assemble OMC
Collar, PIN 115314, to OMC Bearing and Seal Installer, PIN 115310Place the lettered side of the bearing to the collarDrive the bearing in until the installer contacts the top of gearcase
] 3Install the bearing spacerf181 4Install new upper driveshaft bearing using OMC Bearing and Seal Installer, PIN 115310Press against the lettered side of the bearing until the tool is seated on gearcasef171 5Using No.3 retaining ring pliers, install bearing retaining ring with sharp side of ring facing out