1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 165Get this manual
r:j3l22Inspect wrist pin, needle bearings, and washersIf worn, replace all these components23Refer to Cleaning and Inspection at beginning of this sectionAssemblythru Deluxe o
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
Note Use new gaskets, seals, and O-rings during assembly14Note Make sure water deflector is in place1Apply coat of oil to wrist pin and wrist pin hole in pistonr:J5l1612Insert wrist pin through "L" side of pistonInstall wrist pin to inside edge of piston using OMC Wrist Pin Pressing Pin, PI 326624, and OMC Piston Cradle, PI 326572