1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 157Get this manual

1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 157

Assembly
r:=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
Note Use new gaskets and seals during assembly'8l1gl1If removed, install new upper and lower ball bearings using OMC Bearing Installer, PIN 115309When pressing on the bearings, support the crankshaft between the two counterweights and press against lettered side of the bearing2Apply coat of oil to wrist pin and wrist pin hole in pistonr,Ql3Insert wrist pin through either side of pistonOil wrist pin bearing and place into connecting rodPosition the connecting rod into piston with the arrow mark on piston top pointing to bottom of the crankshaftInstall wrist pin using suitable toolInstall new wrist pin retaining ringsr:;::;l4Install piston ring on pistonSpread ring with ring expander just enough to slip it over the head of the piston and down into place