1993 Johnson Evinrude "ET" 2 thru 8 Service Manual, P/N 508281, Page 109Get this manual
Ignition Coil ReplacementCD II Remova l
1Twist and remove cover to remove the spark plug lead and primary leads from the ignition coil2Notice the fastener and washer orientation before removing any screws3Remove the coil mounting screws and remove the coil and washersInstallation
r:jl f'2l1
Assemble the correct sequence of washers and locate the ignition coil on the powerheadInstall and tighten the retaining screws to torque of 48-96 inIbs(5,4-10,8 Nm)
2Apply light coating of OMC Triple-Guard grease to the ribbed portion of the spark plug ceramics and to the openings of each of the spark plug lead coversInstall the spark plug leads3Apply light coating of OMC Triple-Guard grease to the opening of each primary lead cover and install the coversObserve the proper wire routing and ignition timingThe orange blue primary lead must be connected to the No.1 ignition coil