1992 Johnson Evinrude "EN" Electric Outboards Service Manual, P/N 508140, Page 102Get this manual
Assembly 1To replace the latch release rope, cut new rope to length of 45 in(115 cm) 2Tie knot in one end of the rope and thread through the handle, bow arm and latch
11313Tie an overhand knot, and secure with tie strap4 If the latch plates have been removed, install as follows:
Position the latch plate on the deck bracketThe latch plate must be square on the bracket and perpendicular to the latch
Coat the threads of the retaining screw with OMC Nut Lock
1141&Ibs(5-9 Nm)and nut and torque to 60-80 inInstall the screw
5Place the cable drum in the bow arm 6Pos ition the bow arm in the deck bracket
1151 on Install one washer between the bow arm and deck bracket the starboard side1161 Applyign the deck bracket, bow arm, cable pivot pin washer8Al OMC Triple -Guard grease to the drum and Using a