1992 Johnson Evinrude "EN" Electric Outboards Service Manual, P/N 508140, Page 68Get this manual
Steering Cable Adjustment
Adjust the steering control cable as follows:
1141 of1.the threaded range should be approximately in the center The adjustment nut
2 Temporarily install the snap ring
r:J6l r:J7l
3 Rotate the motor tube and steering gear so the two index marks are together4Hold the foot control base firmly against the lower part of the pedal5Adjust the pivot pin to line up with the attachment point
6Remove the cable snap ring and install the pivot pin using two flat washerswave washer and lock nut Reinstall cable snap ring Check cable adjustment: When foot control pedal contacts pedal base, the steering gear index mark should face the motor tube pinion