1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 393Get this manual
Trim Sending Unit Adjustment It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full trim-up positionTo do this, proceed as follows1Turn ignition key to the ON position2Raise the engine with the tilt switch to maximum trim-up position
1321 3Move the angle adjusting rod to the center hole1331 4Loosen the sending unit screws until only snug, so the
sending unit can be pivoted5Lower the engine all the way down against the angle adjusting rodcenter positionadjust the sending unit by pivoting it up or down with screwdriver, until the gauge shows the needle in the center position