1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 390Get this manual
18 C0A2503
on the pump drive coupling The rubber keeper provides cushion between the motor and the pumpIf the keeper is not present, there is chance that the tang on the pump coupling could be broken off when the motor is energizedposition shownUsing the two Allen head cap screws and one hex head screwflat washer, and lock washer, carefully and evenly draw the oil pump down against the manifoldTighten the screws to torque of 25-30 inIbs(2,8-3,4 Nm)The oil pump must be drawn down evenly
r;8l 20Inspect the rubber keeper
1191 21Install the pump coupling in the oil pump in the
201 22Snap the pump filter screen into the manifold as
f211 23Position the manifold so that the pump mounting surface
is levelUsing the correct hydraulic fluid, fill the cavity where the pump is mounted, up to the top of the filterturns clockwise and then several turns counterclockwise until no more air bubbles come out of the pumpIt is very important that the pump area be filled with oil and purged of air because the pump could be damaged if installed drymanifoldInstall new O-ring on the motorPosition the motor on the manifold and install the three screws and lock washersTighten the screws securelyviseSlide the tilt rod and end cap up far enough to be able to install the universal spanner wrench and fill the cylinderFill the cylinder up to oil line hole