1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 389Get this manual
i the valve all the way into the manifoldTighten the
11Oil and install the manual release valve Thread
valve to torque of 45-55 inIbs(5-6 Nm)Using OMCRetaining Ring Pliers, PIN 303857, install the retaining ring with the sharp edge of the ring facing out
112 12Oil and install the trim-up relief valve seat and a-ringPlace the core and spring in the seat1,3l 13Place the steel ball in the manifoldOil and install new filter valve seat and a-ring in the position shown
114 14Insertthe filter up through the manifold plate Using
the three screws, flat washers, and lock washers, secure the manifold plate to the manifoldTighten the three screws evenly so that the plate does not become cockedTighten the screws to torque of 25-30 inIbs(2,8-3,4 Nm)15Clean the oil reservoirInstall new a-ring on the reservoir