1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 378Get this manual
o8 COA2417
f51 1Be sure the manual release valve is screwed in all the EI wayRemove the retaining ring using OMC Retaining Ring Pliers, PIN 303857Remove the manual release valvef61 2Inspect the a-ring in the manual release valve for nicks and cutsInspect the rubber tip of the valve for tears or deformation
[2] 3Remove the oil level plug from the oil reservoirf81
Inspect the a-ring on the reservoir plugReplace the a-ring, If necessaryrigid steel lines connecting the top and
19l Remove the two
EI bottom of the tilt cylinder to the manifoldWhen removing the
line from the top of the tilt cylinder, you will have to hold the tilt cylinder band nut with one wrench while removing the line connector with another
r,Ql 6Both hydraulic lines have a-rings at each endInspect all four a-rings and replace a-rings if necessaryr:J1l 7Position the unit as shownSlide the tilt cylinder retaining pin out ofthe unitRemove the tilt cylinderVery carefully and slowly, cycle the cylinder once or twice while aiming the oil feed ports down toward the oil drain panRemove the two nylon bushings from the cylinder