1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 357Get this manual
Trim Sending Unit Adjustment 1Tilt the engine and engage the mooring bracket
rv 2Temporarily, install PIN 387278 thrust rod in the No.3 hole3Loosen the sending unit screws sending unit can be pivoted
until only snug, so the
4Disengage the mooring bracketLower the engine against the thrust rod
13l 5Observe the trim gaugeIf the needle does not show center
positiontilt the engine up and adjust the sending unit by pivoting it up or down6Lower the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rod