1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 313Get this manual
COB5634
1431 7Push core wire CD (from engine end) through wire clamp Q) until wire is flush, 132 in(0,8 mm), with end of casing
1441 8Turn in set screw on large end of wire clamp until it touches
core wire, then tighten one more full turn to kink and position core wire
Grease trunnion pocket in housing halfLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocketPosition throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screwlever must be in the idle position before reassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop (b)Place casing guide of shift cable between halves of shift leverand shift cable trunnion cap in its pocketGrease outside surface of wire clampInsert clamp through shift lever and casing guide