1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 312Get this manual
OMC Long Life TM CablesInstallation
OMCCable Adapter Kit, PIN 173600, must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control, and pull two halves apart39
1361371 surfaceApply OMC Triple-Guard grease to all points 2Place housing half and cover half on flat
shown in figuresBe sure to grease the three cover screws' threaded holes
COB5630
138 3Lubricate outside of brass sleeves at control end of both
remote control cables with OMC Triple-Guard grease
Place trunnion caps over cable trunnions and slide casing guides over cable sleevesUsing 3132 inhex wrench, start the set screws into each end of both control end wire clamps
1411421 6
Begin cable installations with housing half of controlTo install throttle cable, make certain fast idle lever is completely downMove throttle lever from behind separator plate to expose hole in leverIt is not necessary to remove separator plate to install control cablePlace casing guide between halves of throttle lever and position guide as shownGrease outside surface of wire clamp and insert clamp through throttle lever and cable casing guide