1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 246Get this manual
12 f11l 14V6Align holes in the clutch dog with slot in the
propeller shaftInstall the clutch dog on the shaft with "PROP END" facing rear of the shaft
The clutch dog is not symmetricalIf installed backward, it will not fully engage reverse gear and will immediately damage itself and the gearhole in the shaft with the hole in the clutch dog, install the pin and then, new clutch dog retaining spring Position three coils over each end of the pin, making sure none of the coils overlap or are loosebearing housing with the detent lever toward the topPush the detent lever down, into REVERSE positionBe sure the thrust bearing and the thrust washer are properly positionedInsert the propeller shaft assembly into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housing with OMC Triple-Guard greaseInstall the a-ring into the shift rod coverPlace the shift rod grommet and shift rod spacer (TX models) on the shift rodGrease the threaded end of the shift rod and insert it through the cover bushingTurn the shift rod while pushing it through the bushing to avoid damaging the a-ring