1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 172Get this manual
COB1364
1501 14Lift crankshaft and crankcase heads from cylinder block
and place on bench for disassemblythey were before you removed themInstall the screws finger tight
rs1l 15Replace the rod caps on the rodsOrient them exactly as
Rotate the powerhead so the cylinder heads face upRemove the cylinder heads and gently push up on the connecting rods to remove the piston assembliesProtect the condition of the piston by packing paper towels between the connecting rod and pistonDo not allow the connecting rod to contact the inside of the piston skirt during handlingand discard a-rings To remove seal, insert punch through bottom of bearing to engage seal lip and drive seal out with malletDO NOT reuse sealIf bearing is damaged, crankcase head and bearing assembly must be replaced