1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 139Get this manual
OUTPUT TESTSV6 35 Amp
ill plugs installed and torqued in the cylinder headIf neces-
All cranking output tests must be performed with spark
sary to remove the spark plugs, be sure to keep the spark tester away from open spark plug holes
STEPTOTAL OUTPUT TEST
[!] 1Twist and remove the spark plug leads from all spark plugsr:;] 2Adjust the gap on the spark tester to 7 16 in(11 mm)Connect tester leads to the spark plug leadsSecure tester clip to clean engine ground
To prevent possible arcing of high voltage, route tester leads at least in(51 mm) from any metal surface
i or spark tester during cranking tests
To avoid possible shock hazard, do not handle ignition coils