1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 129Get this manual
OUTPUT TESTSV6 AMP
ill plugs installed and torqued in the cylinder headIf neces-
All cranking output tests must be performed with spark
sary to remove the spark plugs, be sure to keep the spark tester away from open spark plug holesseries of steps will systematically isolate problem area in the ignition systemTo reduce you troubleshooting time and to avoid incomplete results, perform these steps in the order written
f'N=J The following
STEPTOTAL OUTPUT TEST
[!] 1Twist and remove the spark plug leads from all spark plugsr:;] 2Adjust the gap on the spark tester to 7 16 in(11 mm)Connect tester leads to the spark plug leadsSecure tester clip to clean engine ground
To prevent possible arcing of high voltage, route tester leads at least in(51 mm) from any metal surface'" To avoid possible shock hazard, do not handle ignition coils or spark tester during cranking tests3If equipped, install the emergency stop switch clip and lanyard assemblyCrank the engineSpark should jump each tester gap alternately Iftester shows good output on all cylinders, go to STEPRUNNING OUTPUT TEST If tester shows good output on at least one cylinder, go to STEPCHARGE COIL TEST If tester shows no output, go to STEPSTOP CIRCUIT TEST4Refer to Troubleshooting Sequence ChartV6 Amp, V6 35 Amp, Page 3-36Start with your specific fault symptom and continue troubleshooting in sequenceIt is possible for the ignition system to have problem but still produce good outputIf the enginepops" or "backfires" during starting, the ignition may be out of timeCheck the following: Coil primary wire rou ing