1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 69Get this manual
1sl 4Install and secure 1O-in(25 cm) length of 1f4 in(6,35 mm) I.Dclear vinyl hoseA few inches from the loose end, measure carefully, and mark the hose every 12 in(12,7 mm) for three inches (76 mm) 5Fill the hose with Evinrude or Johnson Outboard Lubricant, and run the engine to eliminate air from the base of the hoseShut off the engine, and add or eliminate oil until its level is even with the highest mark6Start the engine, and monitor the pump cycles by using fuel pressure gauge or by putting light finger pressure on the outlet hose At 800 RPM, the oil level in your hose should drop in(25,4 mm) in approximately five pulses At full throttle, the oil level in your hose should drop in(25,4 mm) in approximately three pulses7If your results vary, check the pulse limiter fitting before replacing the pump8If you remove the pump, carefully cut the hose to avoid damaging the fittingWhen installing, use ratchet clamp on the oil supply hoseTorque the screws, pump-to-bracket, to 18-24 inIbs(2-3 Nm)Refer to Hose Routing Chart, this sectionINotel Whenthe oil supply hose, be sure .connections are airtightPoor connections can cause serious powerhead damage