1992 Johnson Evinrude "EN" 90 deg. Cross V Service Manual, P/N 508145, Page 44Get this manual
Synchronization and Linkage Adjustments155 It is important that this step-by-step procedure be followed in sequence and be performed exactly as written to ensure consistent engine idling and smooth operation throughout the RPM range
Remove both remote control cables from the engine before performing the following adjustments
Timing Pointer If the timing pointer or intake manifold has been disturbed, check the top dead center timing pointer alignment
i the spark plug leads and remove the spark plugs
'" 1To prevent accidental starting of the motor, disconnect
Center the timer pointer Rotate the flywheel in clockwise direction until the cast-in TOC mark is approximately 1'2 in(4 cm) past the timing pointer3Install OMC Piston Stop, PIN 384887, in No.1 spark plug hole and turn in center portion until it contacts the No.1 pistonLock the tool in place with ring
IV 4While holding the flywheel firmly against the toolmark the