1992 Johnson Evinrude "EN" 9.9 thru 30 Service Manual, P/N 508142, Page 336Get this manual
Shift Cable20 thru 30 1Place engine's shift lever in NEUTRAL position(Propeller shaft will turn freely when in NEUTRAL position 2Check that remote control handle is in NEUTRAL and the fast idle lever is in RUN position (latched)3Place shift cable through anchor bracket rv i'"l 4Install shift the flat washer and locking nut supplied cable casing guide on shoulder bolt of shift leverInstall
with engineDo not substitute locknutTighten locknut securely5Adjust the length of the shift cable by turning the knurled adjusting nut on the shift cable until the cable trunnion fits into the trunnion anchor pocket in trunnion anchor block
t=J and locknutTighten screw securelyThrottle Cable20 thru 30
'" 6Secure shift cable in anchor bracket by installing screw
1Place throttle cable trunnion into bracketf412Attach spring clip guide by sliding onto side of guide and turning until holes in spring clip snap over both pins on guide