1992 Johnson Evinrude "EN" 9.9 thru 30 Service Manual, P/N 508142, Page 332Get this manual
1431 7Push core wire CD (from engine end) through wire clamp Q) until wire is flush, 1132 in(0,8 mm), with end of casing 1441 8Turn in set screw on large end of wire clamp until it touches
core wire, then tighten one more full turn to kink and position core wire
1451 9Grease trunnion pocket in housing halfLift throttle cable
and rotate cable forward until trunnion cap can be inserted into trunnion pocketCOB5635
1461 10Position throttle lever by hand to align rear hex screw
with access hole in controlInsert hex wrench through hole and tighten second set screwreassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop (0Place casing guide of shift cable between halves of shift lever