1992 Johnson Evinrude "EN" 9.9 thru 30 Service Manual, P/N 508142, Page 323Get this manual
Control Cable Identification 1Install the throttle and shift cables in the remote controlRefer to Cable Installation, Page 9-16 19l 2Put the
handle i.nto NEUTRAL positionThe throttle cable casing gUide will retract completely and the shift cable casing guide will go to the midpoint of its travel
19l 3As you move the control
handle into FORWARD, the shift cable casing guide must retract and the throttle cable casing guide must begin to extend
4As you move the control handle into REVERSE, both casing guides must extend5Identify each control cable for proper installation later
'" Control cable identification and function must be correct before continuing with installation
Control Handle Friction The throttle friction knob must be adjusted just tight enough to eliminate unwanted throttle "creep" under normal operating conditionsr:j'()l 1Turn the knob clockwise to increase friction and counterclockwise to decrease friction2Make preliminary, light adjustment before operating the engine3Make your final adjustment with the boat and engine operating under normal conditionsDR2068