1992 Johnson Evinrude "EN" 9.9 thru 30 Service Manual, P/N 508142, Page 258Get this manual
COA3239
COA3240
49 27Slide the retainer plate down the propeller shaft and into the gearcase with tab facing down
50 i"'"l the 28l
Ring PI install retaining ring Into groove In gearcase with sharp outside edge facing aftThe retaining ring is under extreme pressure during installationWear safety glasses and proceed with care to avoid unsnapping the ring from the pliersLook inside the gearcase and make sure that the ring is seated in groove
1s1l 29:hread one OMC Guide Pin, PI 383175 retainer plate
into the
52 30Stick the reverse gear thrust washer to the back side of the propeller shaft bearing housing with OMC Needle Bearing Assembly Grease53 31 Lightly apply OMC Gasket Sealing Compound to the aft support flange of the bearing housingAlign the propeller shaft bearing housing on the guide pin with the word "UP" toward the top54 32a brass punch and mallet, seat the bearing housing In the gearcase55 33Place new O-rings on the bearing housing retaining screwsApply OMC Gasket Sealing Compound to the O-rings and threads of the screws34Install one screw in the bearing housingRemove the guide pin and install the second screwTighten the screws to torque of 60-84 in Ibs(7-9 Nm)