1992 Johnson Evinrude "EN" 9.9 thru 30 Service Manual, P/N 508142, Page 122Get this manual
Ignition Component Replacement ill
1To avoid accidental starting of engine while servicing, twist and remove all spark plug leads
f61 2Remove the screws retaining the ignition component that is
being replacedr:;l 3If the charge coil or ignition module is being replaced, separate the bullet connectors underneath the ignition module
4Remove the wire clamp from the ignition plate
rv from the powerheadplate screwsLift the ignition plate 5Loosen the five ignition
[!J 6Remove the plate from bottom of the ignition plate7Remove the leads from the spiral wrap and from the ignition component8Apply OMC Ultra Lock to the threads of the component
retaining screwsLoosely install the new ignition component on the ignition plateConnect bullet connector if necessary
f811gl 9