1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 305Get this manual
r:;;l 20Using OMC Rod Holder, PIN 983213, clamp rod tightly in viselubricate end cap and slide it on the rodInstall wear plate on rod end and torque to 84-108 inIbs(9,5-12 Nm) Assembly
L!J cylinder body
f1l 1lubricate five new pump manifold a-rings and place in f21 2Attach pump manifold assembly to cylinder body with three Allen-head screws, and torque to 60-84 inIbs(7-9 Nm)
3Lubricate and install the manual release valveThread the valve all the way into the manifold and torque to 45-55 inIbs(5-6 Nm)Install the retaining ring with the sharp edge of the ring facing outf4l 4Lubricate new motor a-ringPlace it on the motor and attach the motor to the pump manifold assembly with four Pozidriv screwsTorque the screws to 35-52 inIbs(4-6 Nm)Secure wire shield to pump manifold assemblyf51 5Lubricate new reservoir a-ring and place it in the cylinder f61 6Attach reservoir to cylinder body with three Pozidriv screwsTorque the screws to 35-52 inIbs(4-6 Nm)